Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

slow initiation on a 3550 running enhanced image

I'm doing some tests on a 3550 with the enhanced image. It's doing BGP and recieving a default route. Checking the cpu shows minimal load on the switch. However, I am experiencing very slow initiation of a telnet session when I attempt to conenct to it, sometimes in excess of 30 seconds, and about 50% of the time, the session times out before it can initiate. I've gone through some of the ideas of trying to tweak the switch (eg. Running CEF), to no avail. I have even tried modifying the Switch database management templates.

Any ideas would be appreciated.

1 REPLY
Bronze

Re: slow initiation on a 3550 running enhanced image

Try the basic troubleshooting steps.

- Review the switch configuration and interface stats and counters.

- You have low cpu load but how about the memory?

- How about cable length?

- Use another PC to access the switch via telnet.

- Use another port

- Use another cable

Hope this helps.

103
Views
0
Helpful
1
Replies
CreatePlease to create content