Slow Software management process in CiscoWorks 2000 LMS 2.2
I am using Ciscoworks 2000 LMS 2.2 on solaris to upgrade the firmware for all IOS switches. I found that it takes almost 2 hours to complete only 20 devices upgrade!! When I check the job report, I find that each device takes about 6min, more or less, to finish their firmware upgrade process!!! When 20 * 6 minutes, it is approximately 2 hrs!!! I am wondering, if CW2K a single thread application according to s/w management tools? It would be a problem to me as I have 500 devices need to upgrade!!! Anybody can give me clue?
Re: Slow Software management process in CiscoWorks 2000 LMS 2.2
check if rcp is enabled for RME update device SW; do this under RME > Administration > Config Management > Edit Preferences; uncheck "Use RCP for image transfer (When applicable)"; in the same Window check if a user script is supplied. If yes, check the script if it is ok and/or adjust the timeout value.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...