Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SMI upgrade to EMI

I have upgraded a 3550 to EMI image, but it still show SMI:

Switch#show ver

Cisco Internetwork Operating System Software

IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(9)EA1c, RELEASE SOFTWARE

(fc1)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Tue 28-May-02 10:31 by antonino

Image text-base: 0x00003000, data-base: 0x00685778

ROM: Bootstrap program is C3550 boot loader

Switch uptime is 20 minutes

System returned to ROM by power-on

System image file is "flash:c3550-i5q3l2-mz.121-9.EA1c/c3550-i5q3l2-mz.121-9.EA1

c.bin"

cisco WS-C3550-48 (PowerPC) processor (revision E0) with 65526K/8192K bytes of m

emory.

Processor board ID CAT0635Z0F8

Last reset from warm-reset

Bridging software.

Running Layer2/3 Switching Image

Ethernet-controller 1 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 2 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 3 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 4 has 12 Fast Ethernet/IEEE 802.3 interfaces

Ethernet-controller 5 has 1 Gigabit Ethernet/IEEE 802.3 interface

Ethernet-controller 6 has 1 Gigabit Ethernet/IEEE 802.3 interface

48 FastEthernet/IEEE 802.3 interface(s)

2 Gigabit Ethernet/IEEE 802.3 interface(s)

The password-recovery mechanism is enabled.

384K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address: 00:0A:B7:FF:39:00

Motherboard assembly number: 73-5701-06

Power supply part number: 34-0967-01

Motherboard serial number: CAT063506KE

Power supply serial number: DCA063117A6

Model revision number: E0

Motherboard revision number: D0

Model number: WS-C3550-48-SMI

System serial number: CAT0635Z0F8

Configuration register is 0x10F

1 REPLY
New Member

Re: SMI upgrade to EMI

The model number will always reflect what the switch shipped with from Cisco i.e. in your case SMI. You can tell that you are running EMI because the image you are loading has the number "5" as in C3550-i5 indicating EMI. If it was SMI it would be C3550-i9.

Jeff

88
Views
0
Helpful
1
Replies