I'm trying to find a sample config to bridge SNA and IP I have two routers connected together with ethernet ports. They both have Token ring switches on the other interface. The problem is to switch SNA in between the two Token ring networks and IP at the same time. Network on both rings are in the same subnet
It sounds like you need to configure IRB (integrated routing and bridging). You will need to search the Cisco website on IRB to find a sample config as I have never used it in the real world. Once configured, the interfaces will bridge the SNA and IP traffic over both routers. If you struggle to find anythings give me a shout and I'll create an example config.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...