Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

sna connection over a cip-router

hi,

my question:

i have a cisco7513 router which is connected to an ibm host over a cip-card.

there is the following configuration on the card:

.

.

lan TokenRing 7

source-bridge 1127 1 1120

adapter 15 4000.1090.0002

name Geos_Tir

and so on.

there is a sna-server which has a connection to the host over this adapter - everything is fine.

now they want to install a new sna-session (lu6.2) from that server to the same adapter.

but it is not possible to configure the new session on the server with the same sap-value (04) as the first session has.

so we tried with a sap of 08 but it does not work - i think my cip-router only "hears" to sap 04.

is there a possibility to configure a second sap value ?

must this new sap-value also match with the config on the ibm-host ??

any idea ???

thanks a lot !

  • Other Network Infrastructure Subjects
1 REPLY
Bronze

Re: sna connection over a cip-router

As I said previously, there is no SAP value coded on the router. It is specified on the XCA major node only so you need to set up a second XCA major node with the new SAP value.

85
Views
0
Helpful
1
Replies
This widget could not be displayed.