To create more than 1 SPAN session on your cat6k with CATOS you have to use "create" keyword.
Something like this
set span tx create
Remember few guidelines
If you do not specify the keyword create with the set span command and you have only one session, the session will be overwritten. If a matching destination port exists, the particular session will be overwritten (with or without specifying create). If you specify the keyword create and there is no matching destination port, the session will be created
I am posting you the link for cat6k span configuration on catos please read the span session limits and config guideliens
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...