Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

snmp catalyst 3750

I have turned on snmp for a catalyst 3750 but my fluke does not seem to be able to find any of my cisco switches. All I did was turn it on and create a read only community. Is there something else I need to configure?

1 REPLY
Cisco Employee

Re: snmp catalyst 3750

Hi,

Do you know what OIDs the Fluke is polling? Some mibs require the so called Community String Indexing:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00801576ff.shtml

Basically, the read community string (say "public") you configured on the device gives you the

default VLAN 1 info. If you need something (such as BRIDGE-MIB) from VLAN10, you need to change the

community to "public@10" on your Fluke box to poll the Cat3750.

HTH,

Bobby

*Please rate helpful posts.

250
Views
0
Helpful
1
Replies
CreatePlease to create content