my network uses third party software to monitor PVC's traffic graphically and uses Community String "popeye@SM_<MGX8850 Service Module slot number>. to be able to get data from a PVC on that Service Module (i.e. FRSM).
I used AXIS@SM_<slot no of Service Module of MGX8220) for MGX8220 but i'm not getting any data at all from that Module for a PVC. Is there any other Community String that i can use? The software can see the whole MGX8220 box by using "public" snmp, but i can't go further deeper to the service modules.
Re: SNMP/Community string for MGX8820 Service Module
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...