We had one 6006 and two 4006 with as many as 10 3548XL switches in our network. We are using a NNM with Ciscoworks2000 for managing the network. We have configured snmp in all switches and hubs in our network.
The problem is:
1. When I try to see the standard reports in ciscoworks2000, I am getting the reports for all catalyst 3548XL Switches. But the reports for 6006 and 4006 are displayed as NO RECORDS, CHECK WHETHER LOGGING IS ENABLE ON THE DEVICE.
2. The configuration done for snmp are
All traps are enable using command
set snmp trap enable all
Logging to the NMS is enabled with the command
set snmp trap X.X.X.X <CommunityName>
The community name I have given is RW community name. What else i have to do to enable logging.
Thanz for ur help. I have read the file and checked it with my configuration. Everything is ok but still I am unable to get the logs in management station.let me know the configuration i have to do to get it working.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...