Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SNMP Environmentals

Where can I get the exact MIBS to track environmentals (mainly pwr and temp )for 7200, 3600, and 7500?

4 REPLIES
Community Member

Re: SNMP Environmentals

A mib browser is a good tool to have. Good luck.

jimmie

http://www.cisco.com/public/swcenter/netmgmt/cmtk/mibs.shtml

Community Member

Re: SNMP Environmentals

Thanks, but I am new to using SNMP and dont really know how to decode Cisco's MIBS. I am needing the exact MIBS

Community Member

Re: SNMP Environmentals

The MIB you need is CISCO-ENVMON-MIB.my This mib is dependant on the following: CISCO-SMI.my, SNMPv2-SMI.my, SNMPv2-TC.my, and SNMPv2-CONF.my I found all of these at ftp://ftp.cisco.com/pub/mibs/v2 The SNMP version 1 mibs are available under the pub/mibs/v1 directory as well. You may need the v1 mibs depending on what application you are going to compile these into. The OID for the environmental mib is 1.3.6.1.4.1.9.13 The trap notifications are also defined in this MIB so your management station can interpret the messages sent when power or temperature conditions occur on your routers.

Good Luck

Community Member

Re: SNMP Environmentals

Hello,

If I may suggest, get the Cisco Press, Performance and Fault Management publication. It dicusses what snmp is/how to read mibs/and some basic mibs to use when monitoring stuff...Look at chapter 10.

jim

146
Views
0
Helpful
4
Replies
CreatePlease to create content