I have a 6509 which has been configured for SNMP. I am the only person who has access to the switch. When I make a config change on the switch my network monitoring software deoas display an alert notifying me. However, recently it has been notifying me of config changes when there has been none made. Any suggestions as to what may be causing this or how to troubleshoot this would be great.
Anytime a user goes into config mode on a switch and then exits a config change trap will be sent by snmp. Even if the user doesn't make a change it will still send this trap because someone has entered this mode.
Also, it could be another application such as CiscoWorks when it does inventory polling which is doing it to check for config changes.
The best solution would be to use some sort of authentication to tell who is entering config mode.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.