Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP Link Status

My routers are configured to send SNMP traps to one of my servers but I'm getting a lot of link up & down status which I do not want to see.

I've added the following snmp config to the interfaces so that these snmp traps do not occur.

eg.

interface Serial1/6

ip address 192.168.113.9 255.255.255.252

no snmp trap link-status

However I still see them as shown below:

20021007 114734 SNMP 172.16.1.4 Trap(ciscoMgmt.41.2-6.1) ciscoMgmt.41.1.2.3.1.2.15954=LINK ciscoMgmt.41.1.2.3.1.3.15954=4 ciscoMgmt.41.1.2.3.1.4.15954=UPDOWN ciscoMgmt.41.1.2.3.1.5.15954="Interface Serial1/6, changed state to down" ciscoMgmt.41.1.2.3.1.6.15954="16 days 22:29:46" Addr:172.16.1.4 Int:6 Int:1 Tick:"16 days 22:29:46"

20021007 114915 SNMP 172.16.1.4 Trap(ciscoMgmt.41.2-6.1) ciscoMgmt.41.1.2.3.1.2.15955=LINK ciscoMgmt.41.1.2.3.1.3.15955=4 ciscoMgmt.41.1.2.3.1.4.15955=UPDOWN ciscoMgmt.41.1.2.3.1.5.15955="Interface Serial1/6, changed state to up" ciscoMgmt.41.1.2.3.1.6.15955="16 days 22:31:27" Addr:172.16.1.4 Int:6 Int:1 Tick:"16 days 22:31:27"

Am I missing out some config? Do I need to reboot the router after placing the snmp command?

BTW, what does the Tick:"16 days 22:31:27" means?

Thanks.

1 REPLY

Re: SNMP Link Status

Try using both: no logging event link-status and no snmp trap link-status.

I believe the tick is in reference to the "service time log uptime" command, if you set it to date and not uptime, it would display the date/time the event occurred, not the time in relation to how long the router has been up.

Hope it helps.

Steve

667
Views
0
Helpful
1
Replies
CreatePlease login to create content