Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP object for Signal/Noise Ratio on Cisco UBR7100 series CMTS

I've been searching for nearly a whole day now without result, so now I hope anyone here are sharper than I am.

I need to locate the SNMP object that holds the value of the signal/noise ratio for the upstream on a Cisco UBR7100 series Cable Modem Termination System.

I've spent most of this day trying to gather information online, and even tried the needle-in-a-haystack-method of trying to locate a value corresponding to the actual s/n ratio on the CMTS. However, a snmpwalk generates quite a few lines of objects, and since the s/n ratio constantly changes (not much, but enough to make searching impossible) I cannot find the value anywhere in the result of an snmpwalk.

To be sure I'm not misunderstood, the value I'm looking for, is the value shown by a 'show controllers cable 1/0 upstream'. The value I need is the line saying ie. 'SNR 30.1234 dB'.

Any help at all would be extremely appreciated!

Sincerely yours

Service Engineer

Casper Niebe

Arrownet A/S

Denmark

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: SNMP object for Signal/Noise Ratio on Cisco UBR7100 series C

docsIfSigQSignalNoise from DOCS-IF-MIB, cdrqCmtsCmSigQSignalNoise from CISCO-DOCS-REMOTE-QUERY-MIB, cdxIfUpChannelInputPowerLevel from CISCO-DOCS-EXT-MIB can be looked at. It can be polled after enabling remote query.

Two links to useful Tech Tips that cover the details of using SNMP for Remote Query are:

http://www.cisco.com/warp/public/109/remote_query.shtml

http://www.cisco.com/warp/public/109/cable_snmp_faq.shtml

1 REPLY
Blue

Re: SNMP object for Signal/Noise Ratio on Cisco UBR7100 series C

docsIfSigQSignalNoise from DOCS-IF-MIB, cdrqCmtsCmSigQSignalNoise from CISCO-DOCS-REMOTE-QUERY-MIB, cdxIfUpChannelInputPowerLevel from CISCO-DOCS-EXT-MIB can be looked at. It can be polled after enabling remote query.

Two links to useful Tech Tips that cover the details of using SNMP for Remote Query are:

http://www.cisco.com/warp/public/109/remote_query.shtml

http://www.cisco.com/warp/public/109/cable_snmp_faq.shtml

287
Views
0
Helpful
1
Replies
CreatePlease to create content