Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP OID similar to "show cam count dyn" for Catalyst switches.

Hi.

Is it a SNMP OID which is similar to the the command:

show cam count dynamic

I would like to graph this value to see if major changes in the cam table of my switches with MRTG.

Tom-Erik

4 REPLIES
Blue

Re: SNMP OID similar to "show cam count dyn" for Catalyst switch

Have a look at this tech tip which will help you out:

http://www.cisco.com/warp/public/477/SNMP/cam_snmp.shtml

New Member

Re: SNMP OID similar to "show cam count dyn" for Catalyst switch

Well I know about this tech tips but then I must count the number of lines before graphing them. Is it not possibel to read directly the counter for:

show cam count dyn ????

Tom-Erik

Blue

Re: SNMP OID similar to "show cam count dyn" for Catalyst switch

There is no one single MIB object that would give you the output eq of 'sh cam count dyn'.

cwu
New Member

Re: SNMP OID similar to "show cam count dyn" for Catalyst switch

Not only do you have to count it yourself, if you have vlans configured on your switch you have retrieve the CAM separately for each vlan and add them up - as per the tip sheet. Just thought I'd point that out since it eluded me for quite a while.

290
Views
10
Helpful
4
Replies