Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

snmp on 2620xm with EtherSwitch NM

I'm using 2620xm with EtherSwitch NM integrated. Are the following command supported?

* ip mgmt-vlan VLAN_ID

* snmp trap-source VLAN_ID (Vlan_id different from management vlan)

Is it necessary to set up a management vlan (Vlan 1) on the device?

If i connect a 2950 switch to the NM, how could i set up default gateway on the external switch?

Any help appreciated.

Bye

1 REPLY
Bronze

Re: snmp on 2620xm with EtherSwitch NM

If you are using Cisco IOS Release 12.2 ,then the command snmp server trap-source VLAN_ID is supported.

See the URL:http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_c/fcfprt3/fcf014.htm#1001431.

You can find the command reference for 2620xm under this URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/sw_conf/index.htm

109
Views
0
Helpful
1
Replies
CreatePlease login to create content