snmp on 2620xm with EtherSwitch NM

[raffaelegalli]

I'm using 2620xm with EtherSwitch NM integrated. Are the following command supported?

* ip mgmt-vlan VLAN_ID

* snmp trap-source VLAN_ID (Vlan_id different from management vlan)

Is it necessary to set up a management vlan (Vlan 1) on the device?

If i connect a 2950 switch to the NM, how could i set up default gateway on the external switch?

Any help appreciated.

Bye

[s.jankowski]

If you are using Cisco IOS Release 12.2 ,then the command snmp server trap-source VLAN_ID is supported.

See the URL:http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_c/fcfprt3/fcf014.htm#1001431.

You can find the command reference for 2620xm under this URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/sw_conf/index.htm