Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP on a 4006

Hi I need help I'm trying to set the SNMP information on a Cat 4006 Switch but unlike the a 3500 switch which seems pretty straight forward I'm getting confused of which commands allow you to put the cummunity string, contact and location information.

Can some one help.....

Alvan Cottrell

1 REPLY
Blue

Re: SNMP on a 4006

http://www.cisco.com/warp/public/477/SNMP/12.html will tell you how to configure the SNMP Community Strings on the Cat4006 switch. Refer to the section 'How To Configure SNMP Community Strings on a Catalyst Switch' in the above URL.

To set the location, use 'set system location[location_string]' command, where location_string = (Optional) Variable text string that indicates where the system is located.

To set the contact information use the command 'set system contact [contact_string]', where contact_string = (Optional) Variable text string that contains the name of the person to contact for system administration. If no contact string is specified, the system contact string is cleared.

As always, as good practice, refer to the Command Reference at:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/rel7_2/cmd_ref/cr_toc.htm#xtocid14 for details on the above commands as well as other relevant info. Hope this helps.

227
Views
0
Helpful
1
Replies