Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

SNMP quesiton

Hi All,

I saw one sample config to config only some information for the 3550 switch:

snmp-server engineID local 00000009020000B064386E00

snmp-server location xxx

snmp-server contact yyy

snmp-server chassis-id Catalyst 3550

but the sample config does not set the snmp community. Does it work? Because the snmp is disable by default but I don't know if the commands above will activate it. Should the "snmp-server community"command must be used when config snmp? Can anybody tell me? Thank You!

Waimen

  • Other Network Infrastructure Subjects
1 REPLY
Bronze

Re: SNMP quesiton

Hi

You have to set the snmp community to access the switch via snmp.

A sample below:

snmp-server community "switch3550" RO 10

!

access-list 10 permit x.x.x.x x.x.x.x

Hope that helps

Roger

87
Views
0
Helpful
1
Replies