Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

SNMP-SERVER Chassis ID for Cat2950-M

I am trying to configure "snmp-server chassisid" for a Cat2950 (IOS) and it does not accept. Is there any special config to set the serial number is the configuration for this type of switch?

Thanks.

Gilson Machado

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: SNMP-SERVER Chassis ID for Cat2950-M

You can also use the Change Device Attributes in RME to update the serial numbers for the devices.

6 REPLIES
Blue

Re: SNMP-SERVER Chassis ID for Cat2950-M

'sh ver' should should show you this info. Give it a try.

New Member

Re: SNMP-SERVER Chassis ID for Cat2950-M

Thanks for the quick response.

Yes "sh ver" give me that. But how do I have it in the configuration so my Network Management System can pick it?

Thanks,

Gilson

Blue

Re: SNMP-SERVER Chassis ID for Cat2950-M

What is your NMS app?. If the chassis serial number in 'sh snmp' matches with 'sh ver', then the app should pick it up by default. If not, then you need may to use the chassis-id command

New Member

Re: SNMP-SERVER Chassis ID for Cat2950-M

I am using Cisco Works 2000 (RWAN) RME version 3.3.

Blue

Re: SNMP-SERVER Chassis ID for Cat2950-M

You can also use the Change Device Attributes in RME to update the serial numbers for the devices.

New Member

Re: SNMP-SERVER Chassis ID for Cat2950-M

Thanks For the help.

Gilson

Network Engineer - Praxair, Inc

243
Views
5
Helpful
6
Replies
CreatePlease to create content