Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

snmp trap test

what is the command to send a snmp trap test to your nms system on a cisco 3600 router? TQ.

3 REPLIES
New Member

Re: snmp trap test

I don't know of a way to send one out from the router. I'll be intrested to see if anyone knows how. Good question but i'm affraid the anwser is it can;t be done.

Bronze

Re: snmp trap test

I'm not sure if the command below is platform-dependent but you can try:

snmp-server enable traps snmp

If your 3600 has an ethernet interface connected to a host or switch, you can

try disconnecting (and re-connect) the cable from the port. This should send

a snmp Link Up/Down trap to the NMS.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/fun_r/frprt3/frd3001.htm#1113568

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca74d.html#30538

Hope this helps.

New Member

Re: snmp trap test

well this is one way, but you usually don't do this on a router that is carrying live traffic.

Catalyst 6500 can do it, the command is

test snmp trap [trap-number]

so I assume there is a way for cisco router too.

314
Views
0
Helpful
3
Replies
CreatePlease to create content