As the management software, I'm using WhatsUpGold.
The Cisco software version I'm using is 12.0(5.2)XU.
What I can't figure out is how to get stats from a single port using these SNMP MIB entities?
Also, using SNMP Thresholds or SNMP monitoring, WhatsUp offers to check the status of a device rather than merely log the SNMP stats? I will probably have to import the logs into a spreadsheet for calculations / graphs....
How do I get WhatsUp to store / log raw "ifInOctets" / "ifOutOctets" / "IfSpeed" stats??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...