I was looking through the Cisco managment forum and found the following: there is no plans for SNMPv3 support in CW2000. Note that SNMPv2c doesn't give you more security. Note also that CW2000 uses a lot of other unsecure protocols like tftp, telnet and rcp.
Please could you confirm if this is correct, if not could you piont me to where i can configure this as we need to secure the payload between the devices.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...