I have a dos command-line utility called wrnet that allows me to instruct a Cisco router or switch to copy it's running config to a TFTP server via SNMP. Any IOS related products seem to work just fine, but whenever I attempt to use this utility on a CatOS switch it comes back with a "community string error". I have the read community set to our normal read only community, and the read-write and read-write-all are both set to our read-write community string. Are there any commands that I might be missing? I also set my PC up as an SNMP trap receiver with the read-write string but still no luck. Any help would be greatly appreciated!
Ok....I did a show ip permit and saw that my IP address was not listed. I have since added my IP address in the Permit list for SNMP and still get the same result. In my utility it says "Community String error". But I know that I have the same community strings in the switch and the application. Any other ideas?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.