Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

snmpget failed - snmpv3

I got a router with following version.

C2600 Software (C2600-I-M), Version 12.0(7)T.

I got problem for snmpget and snmpset by openview.

How should i configure it ?

Thanks

1 REPLY
New Member

Re: snmpget failed - snmpv3

OpenView NNM uses by default SNMP v1 and v2c. v3 is supported via an add-module from SNMP Research. NNM will use v2c if the device supports it.

What kind of problem do you have.Typically problems are invalid community names or some kind of restrictions (allowed managers or limitations on the branches of the SNMP tree allowed for access (views)).

255
Views
0
Helpful
1
Replies