Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Software forced crash after disabling the encryption on a interface

Hy everybody,

after the command;

Router(config-if)> no crypto map xy

The Router reloads cause of a software forced crash.

Platttform;

cisco 7204 (NPE150) processor with 122880K/8192K bytes of memory.

R4700 CPU at 150Mhz, Implementation 33, Rev 1.0, 512KB L2 Cache

4 slot midplane, Version 1.0

IOS;

ROM: System Bootstrap, Version 11.1(10) [dschwart 10], RELEASE SOFTWARE (fc1)

BOOTFLASH: 7200 Software (C7200-BOOT-M), Version 12.0(13)S1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

Does everybody know the solution to solve this problem.

Thank you very much for your feedbacks

regards

stephan

1 REPLY

Re: Software forced crash after disabling the encryption on a in

Are you a registered user ( CCO login). If yes you should first get the output of "show stacks", "show version etc, and paste it into a tool called Output Interpreter (needs CCO login).

Here is a link to Output Interpreter.

https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl

Check this link for more troubleshooting on Software forced crashes.

http://www.cisco.com/warp/public/122/crashes_swforced_troubleshoot.html

If you are not a reg. user, paste the above command outputs, and we might be able to help.

Hope that helps!@

150
Views
0
Helpful
1
Replies
CreatePlease to create content