Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Software Upgrate 4003 Switch

I am just beginning to do software upgrades and I am starting with our Catalyst 4003 and 4006 switches. I have done everything according to the Cisco book, including the prepend statement. Whenever I restart the switch, the old version still comes up. I do not want to do anything to cause a fatal error. Has anyone encountered and resolved a similar situation?

1 REPLY
New Member

Re: Software Upgrate 4003 Switch

make sure you add

"prepend" at the end of the boot system command

and make sure that config-register is 2102

107
Views
0
Helpful
1
Replies
CreatePlease to create content