Experiencing some problems in the below said scenerio.I had two links for load balancing and also for redundant purpose.
link 1 : Frame-relay link , end-to-end tunnel , RIPv1 routing protocol, bandwidth 64k
link 2: 64 k LL link , end-to-end tunnel . RIPv1 routing protocol,bandwidth 64k
link 1 : end - to-end serial interface connectivity , but using tunnel
link 2: In one end serial and the other end ethernet , but using tunnel
experiencing problem on the second link , enormous error in the NMS and interface, I am suspecting about teh diff. encap on the second link might cause problems , could anybody can advise what could be the reason...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...