some problems with snmp catalyst monitoring (sensor values)
Good day for all.
Recently in our company was installed some snmp monitoring tool, so now I try to configure it to collect some OID's information.
Now i have some bewilderment on some OIS's values:
1. cswSwitchPowerBudget that's OID is 22.214.171.124.126.96.36.199.500.1.2.1.1.9. On all Cisco devices (C3750-X,C2950,C2960) that monitored now it's value is correct and equal 230V, but we have one stack of C2960S and it's value is 0!
2. monitoring of entitySensorMIB get some unclear results, so on all C3750-X the amper sensor show value of 60, but on one of them value is 80. This problemable switch is not stacked and haven't high load and no PoE. Also noise sensors on two C3750-X show over 40dBm, but when i go into rooms they are placed i hear that noice is very low.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...