SONET connexion using Cat6500 Gigabit Ethernet Module
We are attempting to implement an OC-3 SONET Ring connexion (site-to-site) using a WS-X6408A module, but are experiencing time-outs when remote users are working in particular applications. We have had Verizon do thorough tests on the SONET and have seen it run with no errors and at the rated speed. The CISCO set-up is as follows: both ports (remote and local) are set for "autonegotiate" flowcontrol and flowcontrol "desired."; both ports have the same VLAN # and both MSFCs (remote and local) have a VLAN interface with that same VLAN # as well as having distinct IP addresses on the same subnet.
The particulars on the CAT6500 switches are as follows:
Hardware version: 2.0
It seems to me that this might be a flowcontrol problem; we have changed (on both sides) "desired" to "on" with the same poor results.
Re: SONET connexion using Cat6500 Gigabit Ethernet Module
Yes, we are using a GBIC port on a WS-X6408A module in a CAT 6509 switch. This is GE over SONET. The piece of equipment "in between" is a Cisco ONS15454 MUX which is the property of Verizon, the SONET provider.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.