Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

SPAN in Catalyst 6509

We are trying to configure a few SPAN in the same equipment, but only one is allowed. Does anyone know how can I do it?

TIA

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: SPAN in Catalyst 6509

here is what you need to do

set span [source{port/vlan}] [destination port ] {here is where you put your options} create

if you do not add the create at the end the current span session will just be erased. if you add the create at the end a new session will be establised.

here is a list of the options.

[rx | tx | both] [inpkts {enable | disable}] [learning {enable | disable}] [multicast {enable | disable}]

"sho span" to verify config.

Mark Goodson

3 REPLIES
Cisco Employee

Re: SPAN in Catalyst 6509

New Member

Re: SPAN in Catalyst 6509

TIA- Look into RSPAN capabilities of the 6509, it should have what you are looking for...

New Member

Re: SPAN in Catalyst 6509

here is what you need to do

set span [source{port/vlan}] [destination port ] {here is where you put your options} create

if you do not add the create at the end the current span session will just be erased. if you add the create at the end a new session will be establised.

here is a list of the options.

[rx | tx | both] [inpkts {enable | disable}] [learning {enable | disable}] [multicast {enable | disable}]

"sho span" to verify config.

Mark Goodson

153
Views
0
Helpful
3
Replies
CreatePlease to create content