Our NT servers are configured with team NIC. Therefore, 1 NIC goes to switch01 and the other to switch02 with both ports on the same VLAN. A question came up to me on how would we perform a traffic capture if a troubleshooting step required it.
I was thinking of SPAN each respective server switch port and run a cable from the monitor port to a spare simple switch. Then SPAN the 2 ports to a port connected to the packet analyzer.
Anyone care to share how they set theirs up or other alternatives? Thanks.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...