I have been using a 2950XL w/ 2 VLANS for some time on our DMZ (one VLAN for outside and one for the DMZ)and just purchased a new 2950 because a couple of the ports on the 2900XL died... I had it set up before for port fa0/1 to be the span port for ports fa0/2-12 (VLAN 100) and fa0/13 to be the span port for ports fa0/14-24. Each of the span ports were connected to different interfaces on our IDS box. Now with the 2950 i see there is a limitation of only 1 span session!!!??? First why the change? Second does anyone know a way around this?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...