We have 2 -7206VXR Routers w/enterprise ios software, each with subscribers and outbound internet connections on T1 and T3 circuits that need content filtering. We would like to use a a 8e6 Technologies (formerly XStop) R2000 Content Filtering Device for this. It's recommended use is in invisible mode using a span port for intercepting traffic. Is it possible for a 7206 router span traffic to a specific ethernet port? If not what do you think the best bet for this would be? I was thinking perhaps rerouting all traffic that needed to be filtered out one 7206 ethernet port and back through another ethernet port on the same router, what about that idea? There is not clear inlive path to put the filter in since the customer and internet circuits are on the same routers.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...