04-11-2006 05:44 AM - edited 03-03-2019 02:46 AM
Hi all,
I have basic question to SPAN
conf. When I conf. local SPAN, my destination port(on this port I have analyzer) disconnects. After that, DHCP doesnt function. So where I do error?
conf is....monitor session 1 source interface FastEthernet0/1
and
monitor session 1 destination FastEthernet 0/2
RG
jl
04-11-2006 05:49 AM
When you configure SPAN, the destination port no longer passes traffic. Instead it mirrors the traffic from the source address. DHCP requests / responses will no longer pass through this port.
Hope this helps
Martin
04-11-2006 05:56 AM
I addition to the post by Martin, You can use the ingress feature to enable the traffic on the destination port.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12122ea7/scg/swspan.htm#wp1218090
HTH,Please rate if it does.
-amit singh
05-02-2006 09:03 PM
Do you know why I can connect to a SPAN destination port to remote control my portable running sniffer software if I enable ingress forwarding for that monitor session destination port?
This only works with a NIC with enahnced drivers I got from the Sniffer software developers Network General. If I have a portable otherwise connected to the destination port even with ingress enabled I can't connect to it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide