Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Spanning a port on a 3548

Can you set a port on a 3548 to Spanning mode?

So i can capture all the data that is going into the switch from one port.

I cant seem to find a command that allows me to make the port a span port.

Many thanks.

Mike.

1 REPLY
Silver

Re: Spanning a port on a 3548

Hello Mike,

Yes you can. See the example below.

Enable SPAN on interface Fa0/1 to monitor interface FA0/2.

conf t

int fa0/1

port monitor interface Fa0/2

end

Disable SPAN on interface Fa0/1

conf t

int fa0/1

no port monitor interface Fa0/2

end

Refer to the documentation for more information:

http://www.cisco.com/univercd/cc/td/doc/product/lan/c2900xl/29_35wc/sc/swgports.htm#1035723

HTH

Leon

* Please rate posts.

117
Views
5
Helpful
1
Replies
CreatePlease to create content