cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
241
Views
0
Helpful
1
Replies

Spanning-tree in looping

lc.santos
Level 1
Level 1

Hi,

I have one layer 3 switch with 3 gigabit port connecting two sites with fibre. For redundance I have one catalyst connected in G1/1 with directed link laser for other catalyst in site B. But, when up the interface in catalyst the spanning-tree enter in looping. My question is: What is the bether configuration of spanning-tree to prevent this looping? I have that to change some thing in layer-3?

Thanks for help!

1 Reply 1

m.christian
Level 1
Level 1

You may want to check if portfast in enabled on any of these interfaces. If it is, you'll probably want to turn it off.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: