Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

ssg pass-through

Hello all

i am trying to figure out how to apply the command ssg pass-through only for a specific subnet of the incoming traffic from a Serial interface (downlink).

Any examples?

1 REPLY
Bronze

Re: ssg pass-through

Here is a URL that shows how to set it up. Basically you will need to create an access-list for the incoming traffic and specify it after the ssg pass-through command.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123tcr/123twr/wan_s4gt.htm#wp1059049

89
Views
0
Helpful
1
Replies
CreatePlease to create content