I've configured SSH connectivity to my 2600 in the IDS MC, where it was previously working fine using telnet. Once SSH is configured, the telnet connection to the router is dropped, and that's normal, but an SSH session does not begin. With telnet, there was a constant connection, and I'm not seeing this with SSH. I'm able to SSH to the router just fine from the CiscoWorks server, with PuTTY, and also from my workstation with SecureCRT. I don't understand why SSH connectivity does not seem to be working for my IDS.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...