04-21-2006 01:29 AM - edited 03-03-2019 02:53 AM
Hi,
please tell me whats the difference between stacking and cascasding ? and how to configure them ?
regards
Neo
04-21-2006 01:39 AM
Hi Neo,
This link will give you a clear picture of how half duplex cascade looks like and how full duplex stacking looks like
Have a look at Fig 2-3 and Fig 4
http://www.cisco.com/en/US/products/hw/modules/ps5455/products_data_sheet09186a00800a1789.html
HTH, if yes please rate the post.
Ankur
04-21-2006 06:00 AM
Hi Ankur,
Any configuration, how to implement ?
regards
Neo
04-21-2006 08:04 AM
Hi Neo,
According to me there is no special config required because it is not the configuration but the way you connect your switches using giga stack gbic modules.
If you look at the previous link it is just the different ways stacking gbics are used to connect the different switches.
On 3750 switch you get special stacking cables and here you go with the link for 3750 as how to manage stacks
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225se/3750scg/swstack.htm
HTH, if yes please rate the post.
Ankur
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide