Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Standard routing and policy routing?

Hi there!

Is it possible to set up ip policy routing on an interface (using the route-map command matching an ACL and setting the next hop) and use the "standard" routing table when there are no packets matching the ACL?

Or let's put it this way:

If no match is found in the route-map what happens to the packet?

Thank's! :)

Jorge B.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Standard routing and policy routing?

If there is no match, the packet gets routed according to what exists in the routing table.

-HTH

1 REPLY
Bronze

Re: Standard routing and policy routing?

If there is no match, the packet gets routed according to what exists in the routing table.

-HTH

83
Views
0
Helpful
1
Replies
CreatePlease login to create content