Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Stange problem with direction of dialin

Greetings,

I'm expiriencing a strange problem connecting to a cisco 2610.

Setup:

A -|

|- C

B -|

Routers A and B are 3640's with me in the Netherlands, Router C is in the UK. When A or B connects to C with ppp chap, packets can travel to C. However, returnpackets never reach A or B. On C I see a successfull dialer-setup, and with 'debug ip packet' I see the packet being routed to the correct interface. These packets never reach A or B.

The stange thing is: when C dials A or B all is well.

- There are no access-lists on the dialers of C.

- No crypto.

- There is no caller-id when A or B dials C (international call).

- A uses isdn-2, B isdn-30

The config of C (just for A):

interface BRI1/0

no ip address

no ip directed-broadcast

encapsulation ppp

dialer pool-member 21

isdn switch-type basic-net3

no cdp enable

ppp multilink

interface Dialer1

ip address 10.3.0.2 255.255.255.0

no ip directed-broadcast

encapsulation ppp

dialer remote-name A

dialer idle-timeout 600

dialer string 0031xxxxxxx

dialer hold-queue 5 timeout 5

dialer pool 21

dialer-group 1

no cdp enable

ppp authentication chap

ip route 10.1.0.0 255.255.255.0 10.3.0.1

dialer-list 1 protocol ip permit

Could somebody point me in the right direction?

Thanx!

Thomas.

  • Other Network Infrastructure Subjects
1 REPLY
Silver

Re: Stange problem with direction of dialin

Try some other tools like ping and traceroute or debug ip packets with ping . Can you give more details about your problem with a diagram send as a attachment and other router configuration to understand the problem better.

86
Views
0
Helpful
1
Replies