After installing the CiscoWorks 2000 CD-One then follow by the Resource Manager Essentials ver 3.1 for Window NT, I only have the option to select Start Program CiscoWorks2000 Add & Delete ., change integration option and uninstall CiscoWork 2000. I have no other option to run Resource Manager Essential at all. Is there any one have this experience before and able to offer some help.
At the moment I just need to start and run the Resource Manager Essential - Syslog Analysis.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...