Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

startup-config problem

when i issue any command that tries to access the startup-config, i get the warning message: %% Non-volatile configuration memory is being accessed, Try again later". What's causing this? what's the fix? can't find anything on the cisco website.

1 REPLY

Re: startup-config problem

Hi,

which platform are you using?

I noticed something similar in the past on Cat4006.

The reason were some http server configurations and an CatOS bug.

The only solution was a switch reset.

But I also lost a part of the config.

So I strongly recommend an immediate running config backup!!!

Another possible reason might be a network management system failure. It might be trying to read the startup config all the time in a loop.

Regards,

Milan

128
Views
0
Helpful
1
Replies
CreatePlease to create content