I have a minor problem with the startup/running out of sync report. When i make a change on a box with netconfig eg. delete a entry, the running config on the cw2k is updatet due to a syslog message but the startup config is not updatet even I have the "Write running to startup conf" enablet. On the box you can see that the conf. is updatet and the NVRAM is updatet, there is a time diff between these to messages on around 4 min. But the syslog message is send when the conf. is updatet and the running configuration is retrived so startup conf is therefor out of sync.
If i go into the "Search Archive by Device" and look at the device and check the older verion of the config and then check the startup conf. it looks like it trigger an update of the startup, hmmmm
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...