Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Static 3333.0000.000d in CAM table

Hello everyone,

Anyone have a clue to what this is? On a sup720 6500

Thx v.much

Ken

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Static 3333.0000.000d in CAM table

Hi Ken,

The static mac-address you are refering to is programmed in hardware automatically by the supervisor software. This is normal. That's reserved for IPv6's all-nodes multicast.

Have a look at

http://www.faqs.org/rfcs/rfc2464.html for more information.

To stop these from being learned, use

"no ipv6 mld snooping" in global configuration mode.

The learned entries should age out once that is configured and won't be relearned.

HTH,

Bobby

*Please rate helpful posts

2 REPLIES
Cisco Employee

Re: Static 3333.0000.000d in CAM table

Hi Ken,

The static mac-address you are refering to is programmed in hardware automatically by the supervisor software. This is normal. That's reserved for IPv6's all-nodes multicast.

Have a look at

http://www.faqs.org/rfcs/rfc2464.html for more information.

To stop these from being learned, use

"no ipv6 mld snooping" in global configuration mode.

The learned entries should age out once that is configured and won't be relearned.

HTH,

Bobby

*Please rate helpful posts

New Member

Re: Static 3333.0000.000d in CAM table

Brilliant!

thx

6713
Views
0
Helpful
2
Replies