Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static NAT

Hello, good afternoon, in router I have introduced nat static and at the moment it is being used by router, but I need to clear it. The problem is that it says to me that I cannot erase it because this being used at the moment. You know as this static entrance could be erased?

Sorry for my bad english

4 REPLIES
Bronze

Re: Static NAT

Here you go.

cle ip nat trans *

conf t

no ip nat bla bla....

Re: Static NAT

Hi Friend,

AFAIK "clear ip nat trans *" only works for dynamic nat translations.

I will like to know if you are having one static nat or are you also having many static nats and dynamic nat configured on your router.

If you just have one static nat entry you can try

"no ip nat inside source static"

Incase if it does not work try to remove "no ip nat inaise" from the interface and then try to clear the static nat entry.

HTH, if yes please rate the post.

Ankur

Bronze

Re: Static NAT

"clear ip nat trans *" I believe applies to dynamic transaltions.

The "no" form of the ip nat inside source command should remove the statement.

What command are you using?

Bronze

Re: Static NAT

Nevertheless when you get this error message "%Error: Dynamic mapping in use, cannot remove", when trying to remove an ip nat statement, it usually helps to do a "clear ip nat trans *" first. I just took it for granted that was what marquezagustin ment by "it says to me that I cannot erase it because this being used at the moment"

But let's hear what marquezagustin has to say.

Did you find a way to remove the ip nat statement?

251
Views
0
Helpful
4
Replies
CreatePlease login to create content