Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static Route

I have one Cisco 4000 in my office and one Cisco 4500 at the colo. I have 2 ip routes been configured on the Cisco 4500, ip route 0.0.0.0 0.0.0.0 10.0.1.1 (this is the ip address that my ISP has given), I have configured 10.0.1.2 on the Ethernet 1 of my cisco, the other ip route 10.0.1.128 255.255.255.0 Serial 1 (this is pointing to my office), I have ip unnumbered on my Serial 1.

On my Cisco 4000, I have ip route 0.0.0.0 0.0.0.0 Serial 0 ( this is pointing to my colo Cisco 4500 on the T1 loop) and I have ip unnumbered on the interface serial 0, I have 10.0.1.129 on the ethernet 0.

I can ping to 10.0.1.1 from my Cisco 4000 which is there in my office but I can't ping to any other public address.

Please advice as to what is it that I am doing wrong.

Thanks,

Amit

2 REPLIES

Re: Static Route

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Static Route

What i am gussing out of your problem is that they could be the missing DNS enteries.

Try this ,may this will help u out

146
Views
0
Helpful
2
Replies
CreatePlease login to create content