Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Static Routing of DMZ via EIGRP

Greetings -

I am trying to broadcast a dynamic route via EIGRP to our DMZ inside a CheckPoint 4.0 Firewall. Our Internal network is Private IP and the DMZ is public. Since the DMZ (network range / subnet) is not directly connected to our router I cannot broadcast an EIGRP dynamic route. Also we have many static routes out to various vendors that I do not want broacast to all routers so have not used the

R(C-R)#redistribute static command.

Any Ideas?

3 REPLIES
New Member

Re: Static Routing of DMZ via EIGRP

Checkpoint does not understand EIGRP. Its a Cisco only routing protocol. If you need dynamic routing

to go to the Checkpoint, take a look at RIP (version 2) or OSPF

New Member

Re: Static Routing of DMZ via EIGRP

Thanks for the response. But instead of adding another Dynamic routing protocol to my LAN, is there any way for me to redistribute a single static route to all the other routers or do I have to redistribute all of them?

Thanks.

New Member

Re: Static Routing of DMZ via EIGRP

take a look at a distribute list out in the routing process, you can then set up an access list to include or exclude the routes you need.

190
Views
0
Helpful
3
Replies
CreatePlease to create content