Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

status

i have 2801 router ,its fastehernet port is connected to 2950 switch,

the status of the fastehernet port of the router is status:up ,line protocol:down

3 REPLIES

Re: status

Hi David,

Can you please chedk the status on 2950 switch port if it is enable or not.

Line protocol means there is some physical layer related issue.

Just check the port on 2950 switch which is connected to the fastethernet on router and if it is enable try changing the cable.

HTH, if yes please rate the post.

Ankur

Re: status

Physical/data link layer issue or some interface setting.

try hardcoding speed/duplex on both the sides. try changing cable.

HTH, please rate if it does.

-amit singh

Hall of Fame Super Silver

Re: status

Is the router seeing link (is the interface link light on)? I suspect that it is not. I would suggest checking the cable used for the connection. Perhaps you could swap the cable for a know good (straight through) cable.

HTH

Rick

106
Views
0
Helpful
3
Replies
CreatePlease to create content