cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
239
Views
0
Helpful
2
Replies

Steps to boot a C6509 after migration from CATOS-to-IOS

soylo
Level 1
Level 1

I already have migrated my Supervisor1A, from CATOS v5.3(1) to IOS 12.1(8b)E15. I have the following questions:

1.After to upgrade the first SP, the running configuration shows these 3 commans lines:

!

boot system flash slot0:c6sup11-dsv-mz.121-8b.E15

boot system sup-bootflash:c6sup11-dsv-mz.121-8b.E15

boot bootldr bootflash:c6msfc-boot-mz.121-8b.E15

!

In addition, this other information:

C6509-MEM#remote command switch show bootvar

C6509-MEM-sp#

BOOT variable = slot0:c6sup11-dsv-mz.121-8b.E15,1;bootflash:c6sup11-dsv-mz.121-8b.E15,12

CONFIG_FILE variable =

BOOTLDR variable does not exist

Configuration register is 0x2102

Secondary is up.

Secondary BOOT variable = slot0:c6sup11-dsv-mz.121-8b.E15,1;bootflash:c6sup11-dsv-mz.121-8b.E15,12

Secondary CONFIG_FILE variable =

Secondary BOOTLDR variable does not exist

Secondary Configuration register is 0x2102

This is correct? or only must be show some them?

thank you for response.

2 Replies 2

Prashanth Krishnappa
Cisco Employee
Cisco Employee

Best practice would be to boot from sup-bootflash: rather than slot0: The correct command is

boot system flash sup-bootflash:c6sup11-dsv-mz.121-8b.E15

Thanks foe tour response.

What about this command?

boot bootldr bootflash:c6msfc-boot-mz.121-8b.E15

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco